5
CANADIAN EQUIPMENT REQUIREMENTS:
This digital apparatus does not exceed the (Class A / Class B)
limits for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of
Communication. This device complies with RSS-210 of Industry and
Science Canada. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
W415-1026 / A / 06.15.11
10. TRANSMITTER WALL MOUNT: (OPTIONAL)
Secure the wall cradle to the desired wall location using screws, and
anchors if required. If wall mount is not desired wall cradle can be discarded.
FIGURE 18
FIGURE 18
FCC REQUIREMENTS:
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio TV technician for help.
!
WARNING
Changes or modifi cations to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
!
9. FINISHING:
Follow the diagram based on your receiver installation, wall mount or
fi replace mount.
Remove the battery compartment from the receiver by pressing and
releasing. Peel the self adhesive backing off the “PRESS TO OPEN”
sticker and affi x to the front surface of the battery compartment. Replace
the battery compartment into the receiver.
Secure the slide switch horizontally for the fi replace mounting plate and
vertically for the wall faceplate.
PRESS TO OPEN
AFFIX
BATTERY
COMPARTMENT
PEEL
STICKER
PRESS TO OPEN
PRESS TO OPEN
BAT.LOW
OFF REMOTE ON
FIREPLACE MOUNTING PLATE
SLIDE
SWITCH
RECEIVER FIREPLACE MOUNT
FIGURE 17
FIREPLACE REMOTE
ON
REMOTE
OFF
BAT.LOW
PRESS
TO OPEN
PEEL
PRESS
TO OPEN
AFFIX
BATTERY
COMPARTMENT
STICKER
PRESS
TO OPEN
WALL FACE PLATE
SLIDE
SWITCH
RECEIVER WALL MOUNT
FIGURE 16
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
ARNING
W
!
PROPERTY DAMAGE HAZARD.
EXCESSIVE HEAT CAN CAUSE PROPERTY DAMAGE.
The appliance can stay ignited for many hours. Take care to
turn off the appliance if it is unattended by an adult.
FIRE HAZARD. CAN CAUSE SEVERE INJURY OR DEATH.
The receiver causes the ignition of the appliance. The
appliance can turn on suddenly. Keep away from the burner,
especially when operating on the BACKUP switch.
Modifi cation of any part of this kit will void any warranty claims
and could create a fi re hazard.
The transmitter and the receiver are radio frequency
appliances. If the receiver is mounted inside metallic cases,
severe loss of performance (reduction of working range) may
result. When the receiver is installed inside the steel appliance
shell, it is recommended that the transmitter be located no more
than 10’ away for consistent operation.
In the event of prolonged absences, the appliance installed
with an F60 should not be left in thermostat mode or used as a
primary heat source. Use a wall thermostat if required.
For remote video instructions, visit our website at
www.napoleonfi replaces.com.
If your Napoleon remote is not functioning properly, do not return it to the
dealer. Call the Napoleon technical support at 1-866-539-2039 or email us at
care@napoleonproducts.com.
www.FireplaceRemoteControls.com
1.888.977.6849
