W415-4188 / B-0 / 11.13.23
EN
18
finishing
17 1/4”
(438mm)
12 7/16”
(316mm)
4 13/16”
(122mm)
Max. 1/2”
(12mm)
Outside
Appliance
Inside
Appliance
Finishing
Material
Appliance
4.0 finishing material
• Risk of fire!
• Never obstruct the front opening of the appliance.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed or cracked.
• Facing and/or finishing material must never overhang into the appliance opening.
•
Do not finish past the finishing edge trim.
Installing finishing materials past the finishing edge trim will result
in not being able to install and/or open and close the front glass panel.
• Drywall dust may penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy.
4.1 finishing materials
4.1.1 screw-safe areas
1. Both combustible and non-combustible finishing materials can be used for this product installation.
2. Finishing material will be covering the front of the appliance and will butt against the finishing material
edge flange (Fig 6).
Image showing finishing material butting to finishing edge flange
Single-Sided Viewing Installation
• Appliance is fully recessed into the wall
• Front view
only
• Left and right side views are covered
WARNING
Fig. 6
4.2 installing combustible and non-combustible materials.
For illustrative purposes only
.
