W415-1710 / B / 08.17.18
EN
72
finishing
Under normal conditions, there is no reason to remove the fixed side of the firebox glass door.
Servicing can be completed from the access side.
note:
FIXED - SEE-THRU ONLY
F.
Remove GGA from fixed side.
G.
Remove the screws securing the door to the appliance.
H.
Tilt the top of the door forward, then lift it up and out of the bottom door retainer.
I.
When re-installing the door, lift onto the bottom door retainer, tilt the top towards the appliance
and secure with the previously removed screws.
12.8 media tray removal
It is recommended to
only
install media trays
when using sand as media.
Media trays, where supplied, should
be stored in the event it is planned to install alternate media at some point in the future.
Natural gas models only:
Media should be installed evenly across the burner tray but not directly on the
burner ports themselves. Never place media directly on the burner ports as this can result in carboning or an un-
appealing flame characteristic. For propane, refer to conversion kit.
Propane models only:
It is recommended
not
to install the sand pan media trays for propane applications
with other media types (i.e glass). Not only will this provide a clean look to the appliance, but it also results in a
more pleasing and clean burning flame. Media trays should be stored in the event it is planned to install alternate
media at some point in the future.Media should be installed evenly across the burner tray and a moderate amount
of media placed on the burner itself and, if necessary, adjusted to achieve a pleasing flame appearance.
Never
place excessive media on the burner as this can result in carboning or an unappealing flame charac-
teristic. Never place media in the pilot housing or over the pilot.
Always check that the appliance ignites
smoothly across the entire burner to ensure media does not compromise performance. Pay particular attention
when using power vents to ensure media placement does not affect ignition or flame characteristics.
All models:
Never place media in the pilot housing or over the pilot. Always check that the appliance ignites
smoothly across the entire burner to ensure media does not compromise performance. To install optional media,
refer to instruction leaflet included with the media kit.
12.9 optional media placement
