Napoleon MIRAGE 605, Manual

9

www.napoleongrills.com

Maintenance / Cleaning Instructions

Note

: Stainless steel tends to oxidize or stain in the presence of chlorides and sulfides, particularly in coastal 

areas and other harsh environments, such as the warm, highly humid atmosphere around pools and hot tubs. 

These stains could be perceived as rust, but can be easily removed or prevented. To provide stain prevention 

and removal, wash all stainless steel surfaces every 3-4 weeks or as often as required with fresh water and/or 

stainless steel cleaner. 

We recommend this gas grill be thoroughly inspected and serviced annually by a qualified service person.
At all times keep the gas grill area free from combustible materials, gasoline and other flammable vapors and 

liquids.  Do not obstruct the flow of ventilation and combustion air.  Keep the cylinder enclosure ventilation 

openings (located on the cart sides and at the front and back of the bottom shelf) free and clear from debris.

WARNING!

 Always wear protective gloves and safety glasses when cleaning your grill.

WARNING!

 Turn off the gas at the source and disconnect the unit before servicing. To avoid the possibility 

of burns, maintenance should be done only when the grill is cool.  A leak test must be performed annually 

and whenever any component of the gas train is replaced or gas smell is present.

WARNING!

 Always wear protective gloves and safety glasses when servicing your grill.

WARNING!

 To avoid the possibility of burns, maintenance should be done only when the grill is cool. 

Avoid unprotected contact with hot surfaces. Ensure all burners are turned off. Clean grill in an area where 

cleaning solutions will not harm decks, lawns, or patios. Do not use oven cleaner to clean any part of this 

gas grill. Do not use a self-cleaning oven to clean cooking grids or any other parts of the gas grill. Barbecue 

sauce and salt can be corrosive and will cause rapid deterioration of the gas grill components unless 

cleaned regularly.

Grids And Warming Rack

: The grids and warming rack are best cleaned with a brass wire brush during the 

pre-heating period. Steel wool can be used for stubborn stains. It is normal that stainless grids (if equipped) 

will discolor permanently from regular usage due to the high temperature of the cooking surface.

Control Panel

: The control panel text is printed directly on the stainless steel and with proper maintenance 

will remain dark and legible. To clean the panel, use only warm soapy water or stainless steel cleaner available 

from your Napoleon dealer. Never apply abrasive cleaners on any stainless surfaces, especially the printed 

portion of the control panel or the printing will gradually rub off. 

Cleaning Inside The Gas Grill

: Remove the cooking grids. Use a brass wire brush to clean loose debris from 

the casting sides and underneath the lid.  Scrape the sear plates with a putty knife or scraper, and use a wire 

brush to remove the ash. Remove the sear plates and brush debris from the burners with the brass wire brush. 

Sweep all debris from inside the gas grill into the drip pan. 

Drip Pan

: Accumulated grease is a fire hazard. Clean the drip pan frequently (every 4 – 5 uses or as often as 

required) to avoid grease buildup. Grease and excess drippings pass through to the drip pan, located beneath 

the gas grill and accumulate in the disposable grease tray below the drip pan.  To access the disposable grease 

tray or to clean the drip pan, slide the drip pan free of the grill. Never line the drip pan with aluminum foil, 

sand or any other material as this could prevent the grease from flowing properly. The pan should be scraped 

out with a putty knife or scraper. Replace the disposable grease tray every 2 – 4 weeks, depending on gas grill 

usage.  For supplies, see your Napoleon Gas Grill dealer.

Cleaning The Outer Grill Surface: 

Do not use abrasive cleaners or steel wool on any painted, porcelain or stainless 

steel parts of your Napoleon Grill. Doing so will scratch the finish. Exterior grill surfaces should be cleaned with 

warm soapy water while the metal is still warm to the touch. To clean stainless surfaces, use a stainless steel or 

a non-abrasive cleaner.  Always wipe in the direction of the grain. Over time, stainless steel parts discolor when 

heated, usually to a golden or brown hue.  This discoloration is normal and does not affect the performance of 

the grill. Porcelain enamel components must be handled with additional care. The baked-on enamel finish is 

glass-like, and will chip if struck. Touch-up enamel is available from your Napoleon Grill dealer. 

WARNING!

 Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these conditions 

exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill dealer or qualified gas 

installer.