18
TWO PEOPLE ARE REQUIRED
FOR THIS STEP
6 x
N570-0073 (1/4-20 x 3/8”)
3/8
10
Grill Head Installation
PROPANE ONLY
- To avoid assembly difficulties, prior to mounting the grill
head, remove zip tie holding regulator up under control panel. This was installed at
the factory to protect the regulator hose during shipping and is no longer required.
(Take care when removing the tie not to damage the hose). Ensure the regulator
drops into the small opening, between the tank heat shield and the right side of the
cabinet.
Lift grill head and place on assembled cart, lining up holes in top of side cart panels
with holes in bottom of base. Fasten from inside using (4)1/4-20 x 3/8”screws, two
per side. Install battery pack below vent slots on left hand panel using magnet
supplied with battery pack. Plug wire from LED (lights) located underneath control
panel into wire from battery pack. Install rotisserie mount bracket to left side of
barbecue as shown using (2) 1/4-20 x 3/8” screws.
Summary of Contents for MIRAGE 730
