ADD TITLE: CHILD PROOF FUNCTION
This function will lock the keys to avoid unsupervised operation.
A. Press the MODE and UP keys at the same time.
B. To de-activate this function, press the MODE and UP keys at the same time.
76
°F
If the receiver is equipped with batteries they will enable fl ame height control or ON/OFF function to control the
appliance during a power failure. Blower and NIGHT LIGHT operation is not possible. Refer to “APPLIANCE
OPERATION” section when communications between receiver and transmitter have been lost. The receiver will emit
a “beep” sound to confi rm programming has been successful once power is restored. During a power failure, if the
appliance was on, the fl ame height will stay at the setting prior to the failure. If off when the failure occurs and then
turned on, the fl ame height will come on at “HI”. The fl ame height can then be controlled by the remote.
The life span of the remote batteries depends on various factors: quality of the batteries, the
number of ignitions, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD display before all
battery power is lost. When the batteries are replaced this icon will disappear.
When the receiver batteries are low, no “beep” will be emitted from the receiver when it
receives an ON/OFF command. This in an alert for the receiver that there’s low battery. When
the batteries are replaced the “beep” will be emitted from the receiver when the ON/OFF key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the three
position slider switch on the receiver to the “ON” position. This will bypass the remote control feature and the appliance
main burner will come on if the gas valve is in the “ON” position.
76
°F
6.8
child proof function
6.9
low battery / manual bypass
6.10
in the event of a power failure
6.11
manual operation
The appliance can be manually overridden by the optional
remote receiver switch located either on the right side of the
appliance or hard wired into the wall. If necessary, change the
operation from ‘REMOTE’ by either sliding the switch up to
‘ON’ or down to ‘OFF’.
NOTE :
‘ON’ and ‘OFF’ on the remote receiver only controls
the gas.
EN
W415-1673 / A / 10.07.19
35
operation
