Napoleon PLAZMAFIRE WHVF31, Installation And Operating Instructions Manual

21

:&

5.1

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE 
ABRASIVE CLEANERS TO CLEAN GLASS. 

Buff lightly with a clean dry soft cloth. Clean both sides 
of the glass after the fi rst 10 hours of operation with a 
recommended fi replace glass cleaner. Thereafter clean 
as required. If the glass is not kept clean permanent 
discoloration and / or blemishes may result.

HOT GLASS WILL 

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

!

WARNING

9.0 MAINTENANCE

CAUTION:

 Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper 

and dangerous operation. Verify proper operation after servicing. This appliance and its venting system 
should be inspected before use and at least annually by a qualifi ed service person. The appliance area must 
be kept clear and free of combustible materials, gasoline or other fl ammable vapors and liquids. The fl ow of 
combustion and ventilation air must not be obstructed.

1.

In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass to
expose both assemblies.

2.

Keep the control compartment, media, burner, air shutter opening and the area surrounding the logs
clean by vacuuming or brushing, at least once a year.

3.

Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or
are not burning properly.

4.

Check to see that the pilot fl ame is large enough to engulf the fl ame sensor and/or thermocouple /
thermopile as well as reaches the burner.

5.

Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboning
which can be distributed in the surrounding living area.

6.

Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10
second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /
distributor.

40.16

MAINTENANCE

MAINTENANCE

MAINTENANCE

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.

APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.

DO NOT USE ABRASIVE CLEANERS.

!

WARNING

9.1  CARE OF GLASS

9.2  CARE OF PLATED PARTS

6.1

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated 
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean. 
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on 
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance 
is required, just wipe clean as needed.  Prolonged high temperature burning with the door ajar may cause 
discolouration on plated parts.

NOTE: The protective wrap on plated parts is best removed when the assembly is at room 
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat 
source.

7.

Check that the gasketing on the sides, top and bottom of the door is not broken or missing. Replace if
necessary.

8.

Blow or vacuum any dust or debris from the catalyst cells, ensuring they are all free from obstruction.