19
W415-0847 / A / 06.08.10
7.0 OPERATION
If appliance shuts off, do not relight until you provide fresh air. If appliance keeps shutting off, have it
serviced. Keep burner and control compartment clean.
When lit for the
fi
rst time, the appliance will emit a slight odour for a few hours. This is a normal temporary
condition caused by the “burn-in” of internal paints and lubricants used in the manufacturing process and will
not occur again. After extended periods of non-operation such as following a vacation or a warm weather sea-
son, the appliance may emit a slight odour for a few hours. This is caused by dust particles burning off. In both
cases, open a window to suf
fi
ciently ventilate the room.
FOR YOUR SAFETY READ BEFORE LIGHTING:
A.
This appliance is equipped with a pilot which must be lit by hand while following these instructions exactly.
B.
Before operating smell all around the appliance area for gas and next to the
fl
oor because some gas
is heavier than air and will settle on the
fl
oor.
C.
Use only your
fi
nger to push in the gas control. Never use tools. If the control will not push in, do not try
to repair it. Call a quali
fi
ed service technician. Force or attempted repair may result in a
fi
re or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a quali
fi
ed service techni-
cian to inspect the appliance and replace any part of the control system and any gas control which
has been under water.
WHAT TO DO IF YOU SMELL GAS:
●
Do not try to light any appliance.
●
Do not touch any electric switch; do not use any phone in your building.
●
Immediately call your gas supplier from a neighbour’s phone. Follow the
gas supplier’s instructions.
●
If you cannot reach your gas supplier, call the
fi
re department.
LIGHTING INSTRUCTIONS:
1. STOP!
Read the safety information located above.
2.
Turn off all electric power to the
fi
replace.
3.
Open the control door.
4.
Wait
fi
ve (5) minutes to clear out any gas. If you smell
gas including near the
fl
oor, STOP! Follow “B” in the
above safety information on this label. If you don’t smell
gas go to the next step.
5.
Find pilot located behind the burner.
6.
Ensure the on/off switch is in the on position.
7.
Depress and hold gas control while lighting the pilot with the push button ignitor. Keep control fully
depressed for one minute, then release. If pilot does not continue to burn repeat steps 3 through 7.
8.
Releasing the gas control will also ignite the main burner.
9.
Turn on all electric power to the appliance if service is to be performed.
1.
Turn off all electrical power to the appliance if service is to be performed.
2.
Push the on/off switch to the off position.
TO TURN OFF GAS:
GAS
CONTROL
47.15
OXY PROTECTOR
THERMOCOUPLE
PILOT
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
THE GLASS DOOR OPENED OR REMOVED.
!
WARNING
