21
W415-0847 / A / 06.08.10
9.0 MAINTENANCE
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.
CAUTION:
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation. Verify proper operation after servicing. This appliance should be inspected before
use and at least annually by a quali
fi
ed service person. The appliance area must be kept clear and free of
combustible materials, gasoline or other
fl
ammable vapours and liquids. The
fl
ow of combustion and ventilation
air must not be obstructed.
9.0.1
Keep the control compartment, burner, and air shutter opening clean by vacuuming or brushing, at
least once a year.
9.0.2
Check to see that the main burner ignites when the switch for the burner is turned on. A 5 second light-
up period is satisfactory. If ignition takes longer, consult your authorized dealer.
9.0.3
Check that the gasketing on the sides and top of the door are not broken or missing. Replace if necessary.
•
Visually inspect the appliance for carbon buildup.
•
Using a small whisk or brush, brush off the excess carbon and vacuum up or sweep into the garbage.
•
Check the appliance for corrosion of the main burner base.
9.1 CLEANING
This procedure must be performed by a
qualified service person!
Inspect the pilot for any visible
contamination or debris (usually lint, pet
hair, spider webs, carpet fibre, etc.) and
remove.
Disconnect the pilot from the pilot tubing
line, using a 1/2” wrench. Blow out the
housing in the same direction as the gas
flow. Re-install the pilot tube, turn on the
gas and check for leaks.
If this does not improve the perfor-
mance, replace the Oxy Protector with
an exact replacement. The device is
tamper resistant with no field serviceable parts.
46.2
CORRECT PILOT FLAME
(Clean, stable, pronounced
blue flame).
INCORRECT PILOT FLAME
(Flame lifts upwards,
becomes unstable with more
of an orange tip).
HOUSING
