W415-1158 / A / 11.19.13
14
EN
74.1B
Evenly spread the glass media onto the media tray, covering the burner tube and tray.
Do not cover burner ports with glass media. Glass media over the burner ports may cause a “Puffi ng” sound.
To eliminate this sound, simply push the media away from the burner ports.
NOTE: The distribution of glass media over the burner ports will infl uence the fl ame height. When the
fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE
THAT IT IS DRY.
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
DEALER / DISTRIBUTOR.
GLASS MEDIA OVER THE BURNER MUST NOT BE MORE THAN ONE LAYER HIGH. MORE THAN ONE LAYER
OVER THE BURNER WILL CAUSE FLAME LIFTING AND SOOTING PROBLEMS.
!
WARNING
4.3 GLASS
MEDIA
A.
Remove the surround, see “SURROUND INSTALLATION / REMOVAL” section.
B.
Remove the two screws on the upper frame that secure the door.
Loosen the two screws on the lower frame.
NOTE: These lower screws support thr door assembly
and should not be removed.
C.
Lift the door up and off.
B
C
