Mounting Instruction
2-1
2 – Mounting Instructions
2.1 Introduction
This section provides the information needed to install and use your PMM
AS-02, AS-03, AS-04, AS-05, AS-06, AS-07 and AS-08 Antenna set.
Included are information pertinent to initial inspection, interconnection,
environment, mechanical mounting, cleaning, storage and shipment.
2.2 Initial inspection
Inspect the shipping container for damage.
If the shipping container or cushion material is damaged, it should be
kept until the contents of the shipment have been checked for
completeness and the antennas have been checked mechanically and
electrically.
Verify the accessories availability in the shipping referring to the
accessories check list enclosed.
Notify any damage to the carrier personnel as well as the NARDA
Representative.
2.3 Environment
The PMM AS-02/AS-03/AS-04/AS-05/AS-06/AS-07/AS-08 Antennas are
constructed of lightweight corrosion-resistant aluminum or stainless steel,
providing years of indoor and outdoor service.
2.4 Return for service
If the Antenna Set should be returned to NARDA for service, please
complete the service questionnaire enclosed with the Users Manual and
attach it to the instrument.
To minimize the repair time, be as specific as possible when describing the
failure.
If possible, reuse of the original packaging to ship the equipment is
preferable.
In case other package should be used, ensure to wrap the instrument in
heavy paper or plastic.
Use a strong shipping container and use enough shock absorbing material
around all sides of the equipment to provide a firm cushion and prevent
movement in the container.
Seal the shipping container securely.
Mark the shipping container FRAGILE to encourage careful handling.
2.5 Equipment cleaning
Use a clean, dry, non abrasive cloth for equipment cleaning.
To clean the wooden tripod do not use any solvent, thinner,
turpentine, acid, acetone or similar matter to avoid damage to it.
Document ASEN-81109 -
NARDA 2018
Summary of Contents for PMM AS02
