PACIFIC D23
5 |
P a g e
PACIFIC D23
Nardi Compressori – www.nardicompressori.com
1
BASIC INFORMATION
1.01
WARNING SYMBOL EXPLAINED:
This manual contains special messages to bring your attention to important information regarding safety and proper
operation of the machine. The symbol below is placed in different parts of the manual next to paragraphs that all users
must be fully familiar with. Make sure you read all the information carefully to avoid injury and/or machine damage.
1.02
PRECAUTIONS:
The compressors are manufactured in accordance with the EC Machinery Directive 2006/42/EC, in accordance
with the Law on General Product Safety dated 01/05/2004 on noise emissions and in accordance with the
Machinery Directive, Annex I, Section 1.7.4. and following. The machine is constructed in a workmanlike manner
and in accordance with technical and operational aspects of safety management.
NARDi COMPRESSORI also declares that the compressor has been subjected to a compliance pressure test,
certifying with our 'DECLARATION OF CONFORMITY'' that the product complies with Pressure Equipment
Directive 2006/42/EC.
Before using the compressor we recommend reading carefully the following indications:
1. Read carefully the manual for the proper operation of the compressor.
2. Do not allow the air that comes out from the compressor to be directed to people or animals.
3. Do not operate the compressor in damp places and/or places without good air ventilation.
4. Make sure the compressor is placed in a stable position.
5. The maximum pressure of the compressor is clearly indicated on the compressor itself.
6. When using the compressor place it in a fresh, well ventilated location and away from heat sources.
7. The compressor can reach high temperatures during operation.
8. Do not to allow children to handle the compressor even when it is turned off.
9. Do not use the compressor to suck/compress gases other than ambient air or air with an oxygen content higher than
21%.
1.03 BRIEF INTRODUCTION:
PACIFIC D23
is a high pressure compressor used to compress air for breathing in scuba diving, fire fighting and
military applications, among others. The maximum compression pressure can arrive at 420 bar and the exercise
pressure can be 225 bar or 330 bar.
Main parts of the compressor:
•
Pump Unit
•
Electric Motor
•
Series of separators and filter
•
Filling hoses and connectors for cylinders
•
Protection and anti-vibration system
•
Automatic condensate drain*
•
Electronic control system*
•
Automatic start and stop system*
