PACIFIC E23 – EG23
20 |
P a g e
PACIFIC E23 – EG23 Rev.01
Nardi Compressori – www.nardicompressori.com
7.06
CHANGE OIL FILTER (Only for compressors with oil pump):
The steps for changing the oil filter are as follows (this is to be performed at every
oil change):
•
Unscrew the nut of the fitting that holds the tube that
delivers the oil to the last cylinder using a 14mm wrench
and disconnect it.
•
Unscrew the four screws of the oil filter housing using a
Phillips screwdriver.
•
Lift the oil filter housing cap with the tube attached to it
and remove the filter.
•
Check if it is necessary to change the O-ring on the oil
filter house housing.
•
Close everything, turn on the compressor and make sure
there are no oil leaks.
7.07
ALARM OIL LEVEL:
When the oil level drops below the minimum threshold, an alarm (visible and
acoustic), is triggered, with a message on the display that shows the scarcity of oil in
the compressor
.
It is necessary to do a top up of oil to the compressor, as described above, up to the maximum level. Press
"RESET" on the front of the electronic control panel, so as to reset the alarm and then "START" to start the compressor.
In the event that, within a short time, the oil level alarm is triggered again, you need to call a technician to check any
possible anomaly.
7.08
CHANGE INTAKE FILTER:
The filter traps any impurities present in the environment.
It must be replaced at regular intervals as indicated in the maintenance checklist.
It should not be washed but replaced.
The steps for changing the filter are as follows:
•
Release the latches on the lid and remove the filter cartridge.
•
Clean with a damp cloth inside the filter housing and the cap.
Insert the new filter cartridge and close the lid.
OIL LEVEL
