PACIFIC M35
15 |
P a g e
PACIFIC M35 REV.01-17 COD. PA201-M35-ENG
Nardi Compressori – www.nardicompressori.com
5
QUICK STARTING GUIDE
WARNING:
This QUICK STARTING GUIDE does not replace the Operator’s and Maintenance
Manual, but is intended to help the operator start the compressor, with quick and practical advice,
which should be followed with extreme caution and only after having read this manual in its entirety.
We remind you to perform periodic maintenance of the compressor, to avoid unwanted problems.
Getting Started:
-
Place the compressor in the desired location
-
Connect the condensate drain hose at the back of the
compressor
-
Check the oil level
-
Check that the cartridge is inserted inside the filter
housing
-
Plug the power cable into the electrical outlet
-
Turn the line switch on the electronic panel to the
position I - ON
-
Pay attention to
the direction of
rotation of the
electric motor If
the plug was
connected the wrong way the electronic panel will
show “SEQUENCE OR PHASE FAILURE” . In this
case, invert two of the three wires on the plug of the
mains cable.
-
To check if it is rotating in the correct direction: If the
air comes out from the top of the compressor then it is
rotating in the right direction while if the air comes out
from the bottom of the compressor then it is rotating in
the wrong direction.
SEQUENCE
OR
PHASE FAILURE
