PACIFIC M35
19 |
P a g e
PACIFIC M35 REV.01-17 COD. PA201-M35-ENG
Nardi Compressori – www.nardicompressori.com
Oil Characteristics:
Low carbon deposit
No carbonizing effect
Good anticorrosive properties
Physiological and toxicological suitability
7.04 OIL CHANGE:
The steps for changing the oil of the compressor are as follows:
Make sure you have enough oil on hand to make the change.
Switch the compressor on for 15 - 20 minutes to heat the
oil and make it more fluid.
Remove the oil refill plug along with the oil breather extension.
Remove the oil drain plug and before opening the tap make
sure you have a container to catch the exhausted oil.
Close the tap and replace the oil drain plug.
Pour the new oil slowly down the oil filler neck.
Make sure that it reaches the maximum level (MAX).
Do not exceed this level.
Close the oil refill plug.
7.05 CHANGE TYPE OF OIL:
To avoid serious damage to the compressor when changing the type of oil, you must strictly follow the following steps:
•
Follow the steps on the oil change Chapter 7.04.
•
Change or clean all parts that have old oil.
•
After 10 hours of operation of the compressor check if there is contamination.
•
If the oil has been contaminated change it again.
•
Do not mix different types of oil and always use the same type of oil.
7.06 CHANGE OIL FILTER (Only for compressors with oil pump):
The steps for changing the oil filter are as follows (this is
to be performed at every oil change) :
Unscrew the nut of the fitting that holds the tube that
delivers the oil to the last cylinder using a 14mm
wrench and disconnect it.
Unscrew the four screws of the oil filter housing using
a Phillips screwdriver.
Lift the oil filter housing cap with the tube attached to
it and
remove the filter.
Check if it is necessary to change the O-ring on the oil filter house
housing.
Close everything, turn on the compressor and make sure there are no oil leaks.
