English
20
Warranty
We grant warranty for material or workmanship defects of our
devices in conformity with mandatory provisions of the relevant
country, but 12 months as a minimum. The warranty period of 24
months is valid in the EU countries in case of the exclusively private
scope of use (proved by invoice or delivery note).
There is a 6-months warranty for battery cell.
The damages following from natural wear, overloading, incorrect
handling and/or the damages caused by the user or by using the
device contrary to the operating manual or the damages known
upon purchase are excluded from the warranty.
The complaints can be admitted only if the device is sent back
to the supplier or to the Authorized Service Center NAREX in the
non-dismantled state. Keep the operating manual and proofs of
purchase safely.
Otherwise the current warranty conditions and terms of the man-
ufacturer are always valid.
Information about noise level and
vibrations
The values have been measured in conformity with EN 60745.
Acoustic pressure level L
pA
= 88.7 dB (A).
Acoustic power level L
wA
= 99.7 dB (A).
In accuracy of measurements K = 3 dB (A).
ATTENTION! Noise is generated during work!
Use ear protection!
Vibration emission value ah (vector sum for three directions) and
uncertainty K measured in accordance with EN 60745:
Weighed level of arm affecting vibrations is less than 2.5 m.s
-2
.
In accuracy of measurements K = 1.5 m.s
-2
.
The emission values specified (vibration, noise) were measured in
accordance with the test conditions stipulated in EN 60745 and are
intended for machine comparisons. They are also used for making
preliminary estimates regarding vibration and noise loads during
operation.
The emission values specified refer to the main applications for
which the power tool is used. If the electric power tool is used for
other applications, with other tools or is not maintained sufficient-
ly prior to operation, however, the vibration and noise load may be
higher when the tool is used.
Take into account any machine idling times and downtimes to esti-
mate these values more accurately for a specified time period. This
may significantly reduce the load during the machine operating
period.
Certificate of Conformity
ASP 14-2A; ASP 18-2A:
We declare that the device meets requirements of the following
standards and directivesc.
Safety:
EN 60745–1; EN 60745–2–1
Directive 2006/42/EC
Electromagnetic compatibility:
EN 55014–1; EN 55014–2
Directive 2004/108/EC
2013
Narex s.r.o.
Chelčického 1932
Antonín Pomeisl
470 01 Česká Lípa
CEO of the company
01.08.2013
Certificate of Conformity
AN-UNI C:
We declare that the device meets requirements of the following
standards and directivesc.
Safety:
EN 60335–1; EN 60335–2–29
Directive 2006/95/EC
Electromagnetic compatibility:
EN 55014–1; EN 55014–2;EN 61000–3–2; EN 61000–3–3
Directive 2004/108/EC
2013
Narex s.r.o.
Chelčického 1932
Antonín Pomeisl
470 01 Česká Lípa
CEO of the company
01.08.2013
Changes are reserved
Summary of Contents for 65 404 830
