English
16
3 Technical Specification
Model
EVP 13 G-2H3
EVP 13 G-2A
Supply voltage (V)
230
230
Power frequency (Hz)
50–60
50–60
Power input (W)
760
760
Speed under load (rpm)
1st speed gear
0–600
0–600
2nd speed gear
0–1 750
0–1 750
Idle speed (rpm)
1st speed gear
0–1 100
0–1 100
2nd speed gear
0–3 050
0–3 050
Number of impacts (ipm)
1st speed gear
0–22 000
0–22 000
2nd speed gear
0–61 000
0–61 000
Speed pre‑selection
Right‑left turning
Extent of chuck dia. (mm)
1.5–13
1.5–13
Thread on spindle
1/2“–20 UNF
1/2“–20 UNF
Quick‑tightening chuck Auto‑Lock
û
Drilling dia. max (mm)
into steel
13
13
into aluminium
20
20
into wood
45
45
into concrete
20
20
Clamping neck dia. (mm)
43
43
Weight (kg)
2.5
2.6
Protection class
II /
II /
6 Use
The machine is intended for impact drilling in brick, concrete and
stone as well as for drilling in wood, metal, ceramics and plastics.
Machines with electronic control and right/left rotation are also
suitable for screwing and thread‑cutting.
The user bears full responsibility for the consequences of using the
tool for purposes other than the above.
7 Commissioning
Any unauthorised use might cause damage to the tool. Therefore
follow these instructions:
– Always use sharp drill bits.
– Load the tool to avoid any significant reduction of speed or
stoppage.
– Always change the speed gear when the machine is idle or at
the machine slow‑down at low speed, in no case during the
drilling or when the machine is otherwise loaded.
Check that the information on the production plate matches the
real voltage of the power source.
Check that plug matches the type of socket.
Tools designed for 230 V can also be connected to 220/240 V.
ATTENTION!
Noise is generated during work!
Use ear protection!
4 Machine Description
[1a] ..Chuck with ring gear
[1b] ..Quick‑tightening chuck Auto‑Lock
[2].....Spots on spindle
[3].....Clamping neck
[4].....Lever for impact shifting
[5].....Air vents
[6].....Latching pin
[7].....Switch / controller
[8].....Speed pre‑selection wheel
[9].....Alteration switch lever
[10] ..Gear‑shifting lever
[11] ..Additional handle
[12] ..Stop bar
[13] ..Chuck hook
[14] ..Spanner*
[15] ..Socket screw wrench*
*) Some accessories displayed or described here may not be
included in the delivery.
5 Double insulation
To ensure maximum safety of the user, our tools are designed and
built to satisfy applicable European standards (EN standards). Tools
with double insulation are marked by the international symbol of
a double square. These tools must not be grounded and a two‑wire
cable is sufficient to supply them with power. Tools are shielded in
accordance with EN 55014.
Summary of Contents for EVP 13 G-2H3
Page 3: ...3 2 4 5 5 6 7 8 9 10 11 12 15 1b 14 13 1a 14 3...
Page 49: ...49...
Page 50: ...50...
Page 51: ...51...
