INSTRUCTIONS BOOK FOR FURNACE H1
18
5. INSTALLATION AND SET UP
5.1. Machine location
The am is to locate the furnace properly to avoid having to move it; otherwise, the user must follow the
guidelines described in the transport section (nº2). It should be placed on a smooth and levelled surface to
avoid any movement of it during the positioning of the profiles.
5.2. Dimensions y work area
5.2. Dimensions and work area
When the furnace is placed, its dimensions, the safety zone, the work area of the operator and the possible
lengths of the workpiece will be taken into account.
Safety zone: We will place the furnace in a zone free of elements and objects, following the indications of the
following figure.
The oven will be installed in accordance with the regulations in force and will be used only in sufficiently
ventilated places.
The oven can be used by a single operator, which must be work frontally or laterally to the machine to be able
to handle the piece safely.
Before starting the heating of the pieces, with the
Burner
off, the operator will adjust the
material support
,
adapting it to the material profile and its length, as indicated in section 5.6.
Picture 7. Safety zone
5.3. Admissible outside conditions
- Normal temperatura b5 and +40ºC without exceeding an average temperature of +35ºC during 24h.
- Relative humidity betwee 30% and 95% without condensation.
Summary of Contents for H1
