VSP User Manual
10
Version 1.7.92
Chapter 2
Intro to Modeling in VSP
Adding a Part
Let’s get into building a model. The first step is to add a part. At the top of the
Geom Browser Window, select the part type from the pull-down list. For the following
example, select POD. Then click the
Add
button to the left of the Parts window to insert
the part. Figure 1 below shows the Geom window and the list of available parts:
Figure 4: Geom window and list of available parts.
The selected part will appear in the Main Screen, and the Part Window will open.
The Part Window allows the designer to change all of the parameters of the given part.
Note
: If the specific part is deselected by clicking anywhere else in the
Active window, the Part Window will disappear. To have the Part
Window appear again, just click on the part name in the Part List.
To remove a part, select the part from the list under the Active label and click
Cut
.
