Chapter 4:
Designing Wings
VSP User Manual
22
Version 1.7.92
Figure 12: Section Tab in HWB part
Fillet Tab
Joint ID
Choose which joint is to be modified.
Deg Per Seg (for all listed below):
Determines how smooth the blend is between
sections (1 degree is very smooth, 30 degrees is less smooth). This is the angle of each
segment added (5 degree sweep per segment, 10 degree sweep per segment, etc.).
Sweep Fillets
% Span 1:
Blends the two sections connected by the joint selected in the XY plane of the
front edge. This adds swept segments along the percentage length of the span selected
(i.e., a larger percent span selected means that more segments will be added).