Page 16
National Communications
SINGLE LINE INSTALLATION
for
Non PC Recording
1.
Connect the LINE port of the Call Record Unit to any convenient
position on your telephone line, using the supplied telephone cable fitted
with a male plug. It does not matter where it is connected. If you wish
to operate a telephone or other telephone device on the same telephone
socket, then fit both items to the same socket using a double telephone
adaptor (supplied).
2.
A Line Isolation Unit (LIU) is supplied to connect your Recording
Device to your CRU. This is an ACMA safety requirement. Connect the
LIU fitted with an RJ11 plug, direct to the RECORDER port of the Call
Record Unit.
Connect the other end of your LIU fitted with a 3.5mm plug
to the LINE or INPUT port of your recording device.
3.
If your Recording Device has a VOX facility which means that it can
start recording automatically when it detects noise and stops recording
automatically when there is no noise, then you can ignore this step.
If your recording device does not have a VOX facility, then you will need
to connect the supplied cable (with Audio connector) direct to the PC
COM port of the CRU and then connect the other end of the cable to the
external START or TRIGGER connector of your recording device.
4.
Connect the supplied 12V power pack direct to your CRU and
switch the power on at your wall plug.
5
. Four Micro Dip Switches are located on the underside of the CRU
and are used to program the unit with your recording requirements. Set
the position of these switches to suit your recording requirements (see
information detailed on page 18).
6.
Read the instructions supplied with your recording device and set
the system up as per the manufacturers recommendations.
7.
Your RECORD device will be connected and activated automatically
when a call is to be recorded. The RECORD device will stop recording
when the call is complete.
