Page 10
Natcomm
PROGRAMMING
Model LS2 only
CHANGE LINE 2 SELECTION CODE
When SW3=OFF, LINE SELECTOR will only allow access to L2 for outgoing calls
by pressing * .
You can change * to any other single digit, by using the following procedure;
(Note: you must use Line 1 when programming)
1. Connect a standard Telephone to the Device Port of
LS2
.
2. Lift the receiver and Press ### (You will hear 3 short ‘Beeps’)
3.
Press #1x
Where x =
the new single digit Line Change code (0-9, or #).
You will hear 1 short beep to confirm this entry. If you hear 2 beeps, you have
made an incorrect entry and must re-enter #1.
4. Hang Up.
CHANGE LINE 2 WAIT TIME
When * is pressed to select L2 to make an outgoing call, there is no delay before Line
Selector connects to Line 2. A Line Change Delay can be set from 0-9 seconds if
required, by using the following procedure:
1. Connect a standard Telephone to the Device Port of
LS2
.
2. Lift the receiver and Press ### (You will hear 3 short ‘Beeps’)
3.
Press #1x
Where x =
the required Line Change Delay Time (0-9 seconds).
You will hear 1 short beep to confirm this entry. If you hear 2 beeps, you have
made an incorrect entry and must re-enter #1.
4. Hang Up.
