National Communications
Page 9
UPDATING TMP TIME AND DATE
The internal clock of
TMP
is set by DEFAULT to Australian Eastern Standard
Time (Brisbane, Sydney, Melbourne etc). If this unit is to be operated in
SA, WA or NT, you should update the time as detailed below :
Note : The Daylight Savings Facility is set by DEFAULT to DISABLED. If
this unit will be operating in states other than QLD, WA and NT, you may
wish to Enable this facility if accurate Timed operation is important.
Updating the TIME and DATE of
TMP
is achieved by using the Control
Program.
1
.
Ensure that the Time and Date of your PC is accurate. If it is not,
adjust it now so that it is correct.
2
.
Insert a
BLANK
Flash Card in your Flash Card Programmer.
3
.
Enter the ‘Set Unit Date
and Time’ option of the
Control Program.
4
.
Manually change the Date or Time
if required. Press OK to write this
information to the Flash Card.
5
.
Without Delay, insert this Flash Card into your
TMP
unit. The light
on your
TMP
will flash 5 times. Please remove your Flash Card.
6
.
This Time and Date will now be written to the Internal Real Time
Clock of your unit.
