SAFETY INSTRUCTION
The product is intended for internal use. The product has overload, overvoltage and short circuit protection. Use
the product in dry areas and never outdoors. To maintain safety and comply with the intended use (CE), the
product cannot be rebuilt and / or modified. When using the product for purposes not described above, it may
be damaged. In addition, improper use can cause hazards such as short circuit, fire and electric shock. Read
and follow these operating instructions carefully. Please make this product available to others people only with
this manual. This product complies with national and European statutory requirements. All company and
product names are trademarks of their respective owners. All rights reserved.
1. Do not use the shredder in a damp environment or touch the device with wet hands.
2. Never use the product immediately after moving from cold to warm place.
3. The product becomes hot during use. Ensure adequate ventilation and never cover the product when in use.
4. The device is not a toy. Keep them out of the reach of children and pets.
5. If into shredder gets tie, hair or shawl disconnect it immediately from the power source.
6. Do not place your hand too close to the slot.
7. Protect the product from extreme temperatures, direct sunlight, strong vibrations, high humidity,
inflammable gases, vapors and solvents.
8. If it is not possible to continue to operate the product safely, it must be removed from use and protected
against re-use. Ensuring further, safe operation is not possible if the product:
- is apparently damaged,
- does not work properly,
- it was stored in a long time under adverse environmental conditions or has been subjected to heavy
transport loads.
9. Handle the product carefully. Shock, knock, or fall, even at low altitudes, can cause product damage.
10. Observe the safety instructions and use of all other equipment used in connection with the product.
11. Cables should always be laid in such a way that nobody can stumble over them or get stuck in it. It could
minimize the danger of injury.
12. For safety reasons, disconnect the shredder from the wall outlet during a thunderstorm.
13. Never disconnect the cable from the power outlet by pulling the cable. Always pull it out using the handles
provided.
14. Do not touch the shredder if it is damaged. First turn off the power at the appropriate power outlet
(e.g. with a suitable fuse) and then carefully pull out the shredder from the mains socket. Never use the
product if the power cord is damaged.
15. To avoid a danger, the damaged power cord may only be replaced by the manufacturer, an authorized
service workshop or a suitably qualified person.
16. Make sure that the cable is not crushed, bent, damaged by sharp edges or subjected to mechanical stress.
Avoid excessive thermal loads exerted on the cable by extremely low or high temperatures. Do not modify
the power cable. Otherwise, the cable may be damaged. A damaged cable can cause fatal electric shock.
17. If you have any questions regarding the correct connection of the product or service or other types of
questions not included in this manual, please do not hesitate to contact our technical support or
a specialist from another company.
WARNINGS
1. When using the shredder, special attention should be paid to the fingers do not get into the gap, decorative
elements and hanging clothing, tie, hair or other elements that can get into the paper slot.
2. The shredder is used for destroy paper, do not destroy other materials, such as foils, laminated documents,
photos, staples, paper clips, X-rays, cartons, self-adhesive labels, credit cards, CDs, newspapers.
3. Do not shredding damp or wet paper.
4. To maintain the correct operation of the shredder, do not place more than 5 sheets of paper because it may
damage the device that is not covered by the warranty.
5. The "REV" function should be used only in exceptional situations (eg. when a paper jam), do not use
this function too much because it may cause excessive paper to accumulate in the head which may
lead to a decrease in the device's performance.
6. Disconnect the shredder from the power supply before attempting to clean the device or maintenance.
7. IMPORTANT! You should not destroy more than 9 pages at a time. Otherwise, the cutting mechanism may
jam.
8. If the device is not used for a long time, disconnect it from the power supply.
INSTRUCTION OF USE
AUTOMATIC SHREDDING START/STOP FUNCTION
Maximum 5 sheets at the same time (A4 80 g/m2)
- To activate the automatic shredding, move the switch on the AUTO
function.
- After inserting the paper sheets, the shredder will automatically start
shredding the paper thanks to sensor placed inside the slot.
- After each cutting, the shredder working a while until the feed slot will be
empty.
- After finishing the cut, the shredder will automatically stop working.
AUTO - Automatic shredding start/stop function
REV – Reverse function
OFF – Power off
EMPTYING THE BASKET
To empty a full basket follow the steps below:
- Move the switch to the OFF mode
- Take off the upper part of the shredder
- Empty trash
- Put the upper part of the shredder on the basket
TROUBLESHOOTING
PAPER JAM
Move the switch to REV mode for 2-3 seconds.
Set the switch to OFF and disconnect the shredder from the power socket.
Carefully pull the jammed paper out of the slot, then connect the shredder to
the power supply.
Set the switch to AUTO and resume shredding.
THE SHREDDER DOES NOT START
1. Check the basket, if it is full, please empty it.
2. Make sure that the upper part of the shredder has been correctly attached to the basket.
3. Check if the switch is set on the AUTO mode.
4. The paper does not have sufficient hardness to automatically start the device in AUTO mode.
5. Switch off the shredder and wait 60 minutes for the engine to cool down.
WARNINGS:
Pay attention to loose items of clothing eg. ties, jewelry,
and hair or other small objects that can enter the
shredder slot when it’s working and cause injury.
Before operating the device, read the user's manual, store the instructions for later use and
pass it on to the next user. All information contained in the manual must be followed.
The device is not a toy, it should be kept away from children and animals.
Do not place hands or fingers into the shredder throat as serious injury could result.
Do not spray flammable gases and substances on the device, DO NOT USE COMPRESSED AIR
FOR CLEANING - this may cause a fire.
Before placing documents in the slot, make sure that they do not have paper clips. The
shredder destroys small staples, however, it contributes to faster blunting of blades.
CLEANING AND STORAGE
• Always disconnect the device from the power source before cleaning.
• Clean the housing of the device regularly with a soft, damp cloth. Do not use chemicals or detergents to clean
this device.
• The basket should be regularly emptied to prevent the cutting head from jamming.
• Before emptying the basket, set the mode switch to OFF.
• If there is too much jammed paper in the cutting head, move the button several times between AUTO and REV
mode so that the jammed paper is removed from the cutting shears.
• If necessary, use a suitable tool to remove any paper from the cutting head blades.
WARNING!
• Disconnect the device from the power source before manually removing paper debris from the cutter head
blades.
• The blades of the cutting head are sharp! Be especially careful and do not reach directly into the cutting head,
as this may cause injury.
WARRANTY
The product is covered by a 24 months manufacturer’s warranty.
• Non-authorized repairs or taking the device to pieces make the warranty void and may cause the product
damage.
• Dropping or hitting the device may cause damage to the device, scratching the case or other defect of the
product.
• Do not use the product in low and high temperatures, in strong magnetic fields and in the damp or dusty
atmosphere.
OGÓLNE
• The safe product, conforming to the EU requirements.
• The product is made in accordance with RoHS European standard. The standard was issued in order to
decrease the amount of the electronic and electrical waste emitted into the atmosphere.
• The WEEE symbol (the crossed-out wheeled bin) using indicates that this product in not home waste.
Appropriate waste management aids in avoiding consequences which are harmful for people and environment
and result from dangerous materials used in the device, as well as improper storage and processing. Segregated
household waste collection aids recycle materials and components of which the device was made. In order to
get detailed information about recycling this product please contact your retailer or a local authority.
This Impakt S.A. declares that the device complies with the essential requirements and other applicable
provisions of the applicable EC directives. Full text of the CE declaration can be downloaded from the website of
the distributor www.impakt.com.pl.
MORE INFORMATION ON OUR WEBSITE: WWW.NATEC-ZONE.COM
EN
PL
Summary of Contents for BEAVER HOME
Page 1: ...BEAVER HOME User Manual ...
