NATI BlueMAX 53542, Manual

“0“.

Normal procedure:

Let go of the throttle lever and wait until the 

engine has changed to idling speed. Then set the 

7.4 Fitting the shoulder strap

Important! Always use the shoulder strap when

(risk of injury).

1. Slip the shoulder strap over your shoulder.

2. Adjust the length of the shoulder strap so that

the strap attachment is at waist level.

7.5 Work practice

Practice all the work steps with the engine 

equipment.

8. Working with the chainsaw

Preparations

To ensure that you can work safely, check the 

following points before every use:

Condition of the chainsaw

Before you start your work, inspect the chainsaw

for damage to the housing, the chain and 

the cutter bar. Never use a chainsaw which is 

obviously damaged.

Oil container

Level of oil in the oil container: Both before and

during your work make sure that there is always

the chainsaw, never run the saw if there is no oil 

in the system or if the oil drops below the „min“ 

mark.

minutes depending on the number of pauses in

cutting and the loads involved.

Chain

Tension of the chain, condition of the cutting

starter cable (Fig. 2/Item 13) until you feel it

begin to resist. Then tug sharply on the starter

cable 4 times. The equipment should start.

Important: Never allow the starter cable to

snap back. This may result in damage.

Once the engine has started, move the choke

lever immediately to “   “ and allow the 

equipment to warm up for approx. 10 seconds.

Important: Since the throttle lever is secured,

the cutting tool starts to operate when the

engine is started.

Then release the throttle lever by actuating it

once.

6. If the engine does not start up, repeat steps

4-6 above.

Please note: If the engine does not start up even

after several attempts, read the section “Engine

troubleshooting“.

Please note: Always pull the starter cord out in

a straight line. If it is pulled out at an angle, then

friction will occur on the eyelet. As a result of this

friction, the cable will become frayed and will

wear away faster. Always hold the starter handle

when the cable retracts.

Never allow the cable to snap back when it has

been pulled out.

7.2 Starting with a warm engine

(The equipment has been idle for less than 15-20

min.)

1. Set the equipment down on a hard, level 

surface.

2. Switch the On/Of switch to “I“.

3. Secure the throttle lever (in the same way as

described in “Starting with a cold engine“).

starter cable until you feel it start to resist.

Then tug sharply on the starter cable. The

equipment should start after 1-2 tugs. If the

equipment does not start after 6 pulls, repeat

steps 1 – 7 of the procedure for starting the

engine from cold.

Eme

7.3

rgency Stop procedure:

If it becomes necessary to stop the equipment 

1-800-348-5004

feedback@natitools.com

13