![background image](http://html1.mh-extra.com/html/national-cycle/quantum-hardcoated-n30214-wk/quantum-hardcoated-n30214-wk_assembly-instructions-and-owners-manual_3387346005.webp)
National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
P: 708-343-0400 / F: 708-343-0625 / E: info@nationalcycle.com
www.nationalcycle.com
©2021 National Cycle, Inc.
Page 05 of 13
10-118625-000 03/21
PREPARATION AND ELECTRICAL WIRING; CONT’D.
Figure 16
Locate the section of Wire Harness that terminates in a Small Silver Nylon
Pin Connector, Small Orange Nylon Pin Connector, and connected Two-
Way Pump Switch
(III)
. Temporarily remove the Pump Switch and thread
the wiring under the hood toward the hole you cut in the dash panel’s
accessory switch cover in
Figure 1
.
Figure 17
Move inside the vehicle’s cab and secure the two Nylon Pin Connectors.
Figure 18
Reattach the Two-Way Rocker Switch to the two Nylon Pin Connectors
(polarity doesn’t matter) and then push the Rocker Switch into the cutout of
the accessory switch cover.
Figure 19
Completed dash panel Rocker Switch should appear as shown.
Figure 17
Figure 16
Figure18
Figure 19