National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 www.nationalcycle.com e-mail: info@nationalcycle.com
©2019 National Cycle, Inc.
Page 2 of 3
10-110802-000 06/19
Fig. 04
Fig. 05
Fig. 06
Fig. 07
Fig. 08
INSTALLATION; CONT’D
6.
Place the new windscreen into position and reinstall the two
6x12 10mm Bolts and 9.5x18 Washers securing the windscreen
at the top left/right.
Fig. 04
7.
Reinstall the two 5x14 Panhead Allen Screws and 5mm
Thrust Washers securing windscreen at the bottom left/right,
making sure the threads capture the internal Wellnuts.
Fig. 05
8.
Replace the windscreen cowl by aligning the top tabs with the
top slots and the hidden tabs with their hidden slots.
Fig. 06
While reinstalling the cowl, push down on the metal tab at the
bottom front and make sure the plastic cowl goes above it.
Fig. 07
Installing the cowl correctly requires patience and may take
more than one attempt. Be careful not to break the plastic tabs.
9.
When the cowl is completely installed, make sure the 20x25
Dual Lock™ Fasteners under the front end are rejoined and
then reinsert the two 4x16 Self-Tapping Phillips Screws under
the nose of the new windscreen.
Fig. 08
You’re all done.
Enjoy the ride with your new Windscreen!
