National Electronics & Watch Co, Ltd.
BC10
5.4.2)
Press S5 to stop after completing your run.
5.4.3)
Press and hold S5 again to save your data.
Step 6) Download your data to PC:
The watch comes with PC software to make communication between your watch and PC
easy and enjoyable. Please install the PC software to your PC using the installer provided.
The watch is using a USB PC link cable to connect the watch to PC.
Run the GPS PC software on your PC. Plug the USB cable with the watch clamped in the
other end of the cable. PC software will then prompt you to download the data. Click the
download button to begin downloading. The PC software will prompt to delete the data in the
watch. User has the option to delete the data in the watch or not.
The PC software installation and instruction guide can be found at the end of this manual.
Please take time to read the guide.
General Operations
The watch has the following main modes: Time, Run, Chronograph, HRM, RUN Data, Timer
Alarm and Set modes. Press S7 to scroll through these modes.
Watch reset:
The user can reset the watch by pressing and holding S1, S5, S7 and S11 simultaneously. All
segments will be light on, then EL backlight ON. The software code will be displayed. The
watch will be reset. Below are the reset views.
EL backlight:
This watch has a
Night mode function
. Following are the options in SET mode and their
functions:
10 SECONDS
– Press S11 will turn ON the Light for 10 seconds.
20 SECONDS
– Press S11 will turn ON the Light for 20 seconds.
NIGHT ON
– Light will continuously ON when CHRONO is running from 6:00 pm to 7:00 am.
But when CHRONO is stopped or reset from 6:00 pm to 7:00 am, press any key can turn ON
the light for about 10 seconds.
TIME MODE
Following are the views with the corresponding information displayed:
Time 1 or Time2, Month, Date, City code, Weekday and battery level indicator.
Note: While in Time mode, User has an option to use a short cut key, press S1 to go to RUN
mode while press S5 to go to HRM mode.
TIME/NIGHT/CONTRAST/CHIME setting in Time mode:
Press and hold S11 until the “TIME” blinks. Press S1 or S5 to select any of the sub views:
TIME, NIGHT, CONTRAST and CHIME setting. Press S3 to enter selected sub-views.
Press S1 or S5 to change the value. Press S3 to enter. Press S7 to exit setting.
TIME 1 setting in TIME mode:
You have two options in setting the watch,
GPS
or
MANUAL
. In manual setting, you can
manually set the time. If you select the GPS option, the watch will be automatically set
based on the data and time data from GPS satellites.
•
Press S3 and Time 1 appears.
•
Press S1 or S5 for Time 1 or Time 2 setting
•
Press S3 to confirm
