Confidential Page
3
6/23/2014
BEFORE INSTALLING
Prior to the installation process, thoroughly review and adhere to the following
items.
Installation
Manual
Use only a Digital or Analog Volt Meter - DO NOT USE TEST LIGHT!
Check for possible installation locations for the GPS unit prior to
permanent installation.
ALWAYS LOOK BEFORE DRILLING. Make sure that the installation
process does not cause damage to any vehicle hose, electrical loom, or to
any part of the vehicle.
Make note of the unit serial number prior to installation.
Prior to working on any part of the dashboard (instrument cluster, center
console, glove box, etc.), remove the negative and positive terminal from
the battery to deactivate the sensors for the airbags. Refer to the Owner’s
Manual and to a Shop Manual for the vehicle for specific instructions in the
temporary disconnection process.
DO NOT place objects, including communication equipment, in the area
over the airbag or near the airbag deployment area.
Refer to the Owners Manual and to a Shop Manual of the vehicle for
specific information related to the electrical wiring, interior disassembly,
and any other mechanical aspects of the vehicle.
TOOLS NEEDED FOR INSTALLATION
Metric and standard socket set
Screwdriver
set
Side cutters, wire cutters
Wire
strippers
Pliers
Terminal
crimpers
Digital
Multimeter
Electrical
tape
Flashlight
Warning: It is highly recommended that a Digital Multimeter be used when
probing electrical systems in the vehicle to prevent damage to factory
components.
