Maintenance
22
CHANGE REAR WHEEL (FIG. 1)
1. Jack machine up by pushing the cylinder lift forward to lower and adjust the angle
of the cutting head to raise machine.
2. Place blocks under forklift cups on the side of the machine that wheel is being
changed.
3. Let cylinder down resting machine on blocks allowing rear wheel to be lifted off the
floor.
4. Remove five 1/2’’ lug nuts with an extended arm wrench, remove wheel.
5. Replace wheel.
6. Replace five lug nuts and tighten, making sure lug nuts are very tight.
7. Raise cylinder to raise machine off of blocks. Remove blocks and lower machine.
8. Repeat to other side if necessary.caster wheel maintenance
CHANGE CASTER
Keep clean and free of debris; ensure it can move freely.
1.
Give a shot of grease in grease fitting on caster every month to keep caster moving
freely.
2. To remove caster, machine will need to be raised. Push the cylinder lift lever for-
ward to lower and adjust the angle of the cutting head to jack up the machine.
Block up machine with wooden block. Remove four bolts, pull caster off and clean/
replace as needed.
3. Replace caster.
4. Pull caster toward rear of machine; re-place and tighten the four bolts.
5. Lower the machine.
CHANGE MOTOR
1. Disconnect motor from power.
2. Undo strap and bolts. Unplug (3) electrical connectors for charger and light.
3. Remove both rear hood and front hood cover.
4. Remove pump.
5. Loosen screws and nuts.
6. Raise motor; disconnect electrical connections.
7. Remove and replace motor.
8. Reverse steps for installation.
SEAT REPLACEMENT
1. Undo strap and bolts. Unplug (3) electrical connectors for charger and light.
2. Remove both rear hood and front hood cover.
3. Remove four nuts securing seat rails. Replace seat; screw on nuts.
FIG. 1
403706_5000_RevF
Summary of Contents for 5000
Page 2: ......
Page 17: ...THIS PAGE INTENTIONALLY LEFT BLANK 17 403706_5000_RevF...
Page 42: ......
Page 43: ......
