UNPACKAGING
Important!
It is highly recommended you retain the box and packing your binder was sup-
plied in for storage, transporting, or if necessary, shipping the binder for service.
Replacement shipping cartons can be purchased.
For equipment to be returned, please call NFE at 1-800-245-0267.
Each new binder is furnished with the following items:
• Instruction manual
• Top thread (spool)
• Binding tape discs (front and back)
• Binding tape centering plug
• Binding tape (1/2 gross)
• Serging tape sample
• Lubricant
• Accessory kit (see Accessories section for items included in kit)
THREADING THE MACHINE
1. Raise needle to highest point.
2. Thread by following the letters indicated in Figure 1.
A. Upper thread tube and guide
B. Enter tension discs
C. Exit tension discs
D. Take-up spring
E. Take-up arm
F. Lower thread tube
G. Needle block
H. Needle (see Figure 2)
Note:
Ensure thread is bottomed in the tension disc (B and C in Figure 1). This is
extremely important! Thread needle from left to right or from the outside to the inside
of the machine.
3. Remove bobbin case.
A. Rotate handwheel toward you until needle reaches its highest point.
B. Tilt machine to rest on handwheel end. If you have binding tape installed, use
a small block to support machine on handwheel to prevent the tape discs from
breaking.
C. Lift and grasp bobbin case latch (Figure 3 on following page).
D. Remove case by pulling towards you.
Operation
10
FIG. 1
WARNING:
FOR YOUR SAFETY, DISCONNECT THE POWER SOURCE TO
THE BINDER BEFORE ATTEMPTING TO SERVICE OR ADJUST THE MACHINE.
FIG. 2
EYE
SCARF
Needle as Viewed
from Front
Thread Machine
from Left to Right