National Flooring Equipment DL2000, Operating & Service Manual

Safety

12

ELECTRICAL PRACTICES

EXTENSION CORD REQUIREMENTS

• 

Ensure the cord type is suitable for the application and location. If you are unsure about your cord type, consult a qualified electrical profes

-

sional or electrician.

•  FULLY INSERT plug into outlet.
•  Do not use excessive force to make connections.
•  Never unplug by pulling the cord from the outlet. Pull plug rather than cord to reduce the risk of damage.
•  Regularly examine your extension cord and ensure it is in good electrical condition. Never use a damaged cord—either replace it or have 

it repaired by a qualified person.

•  Protect your extension cords from sharp objects, excessive heat and damp or wet areas. Keep the cord away from oil, cutting edges and 

moving parts.

•  Do not drive, drag or place objects over cord.
•  Avoid overheating. Uncoil cord and do not cover it with any material.
•  Avoid accidental starting. Be sure equipment is turned off before plugging in. Do not use equipment if the power switch does not turn the 

equipment on and off.

•  Make sure equipment is not running before disconnecting cord.
•  Unplug equipment. When not in use and before changing accessories or performing maintenance, unplug the machine.

EXTENSION CORD SELECTION

All cords should be sized appropriately to reduce the risk of damage, fire or reduced performance. Reference the table in this section for cord 

sizes.

WARNING:

 ELECTRICAL CORDS CAN BE HAZARDOUS. MISUSE CAN RESULT IN FIRE OR DEATH BY ELECTRICAL SHOCK. READ 

CAREFULLY AND FOLLOW ALL DIRECTIONS.

WARNING:

 GROUND YOUR EQUIPMENT. THE EQUIPMENT MUST BE PLUGGED INTO AN APPROPRIATE OUTLET, ONE WHICH 

IS PROPERLY INSTALLED AND GROUNDED IN ACCORDANCE WITH ALL CODES AND ORDINANCES. DO NOT MODIFY THE PLUG 

PROVIDED WITH THE EQUIPMENT. NEVER REMOVE THE GROUNDING PRONG FROM THE PLUG.

CAUTION:

 ALWAYS FOLLOW APPLICABLE ELECTRICAL CODES, STANDARDS AND/OR REGULATIONS. CONSULT YOUR LOCAL 

ELECTRICAL AUTHORITY OR A LICENSED ELECTRICIAN BEFORE ATTEMPTING TO MODIFY AN ELECTRICAL INSTALLATION. ENSURE 

THAT CIRCUIT AND GROUND FAULT PROTECTION DEVICES AND ALL OTHER ELECTRICAL SAFETY EQUIPMENT ARE FUNCTIONING 

PROPERLY.

WARNING:

 DO NOT REMOVE, BEND OR MODIFY ANY METAL PRONGS OR PINS OF THE PLUG. MODIFICATIONS TO POWER CORDS 

AND/OR PLUGS MAY RESULT IN INJURY AND/OR EQUIPMENT DAMAGE.

402539_DL2000_RevJ