Recording the Elapsed Time and Accumulated Elapsed Time
From the "All-Zero" display, press the S/S button to start the chronograph.
Press the S/S button once again to stop the chronograph. The elapsed
time will appear on the display. Repeat this step to get the accumulative
elapsed time.
Measuring Lap Times
To store a lap time, press the L/R button at any designated moment while
the chronograph is running. The stored lap time and lap number will
appear on the display for about ten seconds. The chronograph keeps
running. Once the running time display resumes, press the L/R button at
any designated moment to store another lap time.
Recalling Lap Times
In chronograph mode, hold down the M button to enter the Lap Time
Recall Sequence and the total accumulative elapsed time will be exhibited.
Press S/S or L/R to select a target lap for the recall.
Hold down the M button to exit the recall display.
To record a new set of lap times, hold the L/R button for two seconds in
the chronograph display.
Resetting the Chronograph
To measure a new elapsed time, reset the chronograph to the "All-Zero"
display.
- To reset the chronograph to the "All-Zero" display, press and hold the
L/R button for two seconds while the chronograph has stopped.
Note: When the chronograph has been reset, the elapsed time,
accumulated elapsed time, and lap time memories will be erased.
10
Summary of Contents for NG704 SERIES
