NI 9146 Operating Instructions and Specifications
10
ni.com
Figure 12.
Installing an I/O Module in the Chassis
3.
Squeeze the latches and insert the I/O module into the module slot.
4.
Press firmly on the connector side of the I/O module until the latches
lock the I/O module into place.
5.
Repeat these steps to install additional I/O modules.
Removing I/O Modules from the Chassis
Complete the following steps to remove a C Series I/O module from the
chassis.
1.
Make sure that no I/O-side power is connected to the I/O module. If the
system is in a nonhazardous location, the chassis power can be on
when you remove I/O modules.
2.
Squeeze the latches on both sides of the module and pull the module
out of the chassis.
1
Insertion Groove
2
Latch
1
2
