section for more information about resetting the IP address. You also
can push this switch to the ON position to unlock a chassis that was previously locked in
MAX.
Understanding LED Indications
The following figure shows the NI 9148 chassis LEDs.
Figure 13.
NI 9148 LEDs
POWER
USER FPGA1
STATUS
POWER LED Indicators
The following table lists the POWER LED indicators.
Table 2.
POWER LED Indicators
LED Color LED Pattern
Indication
Green
Solid
The NI 9148 is powered on and the connected power supply is
adequate.
—
Off
The NI 9148 is powered off.
User LED
You can define the USER FPGA1 LED to meet the needs of your application. The following
table lists the USER FPGA1 LED indicators.
Table 3.
User LEDs
LED
LED Color
Description
USER FPGA1 Green/Yellow Use the LabVIEW FPGA Module and NI-RIO Device
Drivers software to define the USER FPGA1 LED. Use the
USER FPGA1 LED to help debug your application or
retrieve application status. Refer to the
LabVIEW Help
for
information about programming this LED.
STATUS LED
The STATUS LED is off during normal operation. The NI 9148 indicates specific error
conditions by flashing the STATUS LED a certain number of times every few seconds, as
shown in the following table.
NI 9148 User Manual
|
© National Instruments
|
13
Summary of Contents for 9918
Page 1: ...NI 9918...
