© National Instruments
|
3-1
3
Safety Information
Safety Requirements
The following general safety requirements and specifications must be observed during all phases
of operation of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in the system documentation violates safety standards of design,
manufacture, intended use, and could invalidate the warranty of the system. This equipment
contains voltage hazardous to human life and safety, and is capable of inflicting personal injury.
NI assumes no liability for the customer’s failure to comply with these requirements.
Note
Using the ATE Core Configurations, or any component within, in a manner not
specified by the manufacturer may reduce or eliminate equipment and/or personnel
safety measures.
Caution
Where this symbol is used, documentation must be consulted.
Before connecting the system to a power source, read this section and verify that you have
complied with all safety requirements and specifications.
Caution
Before undertaking any bring up, troubleshooting, maintenance,
or exploratory procedure, carefully read the following caution notices.
Note
Refer to the
APC UPS Operation Manual
for detailed information and
specifications for this accessory if applicable.
AC Mains Cables
The following cables are available from National Instruments under the following orderable
part numbers:
Table 3-1.
Low Power Configuration Power Cables
Part Number
Description
785708-01
AC, IEC C19 to NEMA 5-20P, 2.5 m
785714-04
AC, IEC C19 to CEE7, 3P, 16 A, 2.5 m
785714-09
AC, IEC C19 to CEE7, 3P, 16 A, 2.5 m (KCC)
785714-10
AC, IEC C19 to GB3, 3P, 16 A, 2.5 m
