2
|
ni.com
|
BNC-2120 Installation Guide
What You Need to Get Started
To set up and use your BNC-2120 accessory, you need the following:
BNC-2120 accessory/accessories
1
BNC-2120 Installation Guide
One of the following DAQ devices:
–
68-pin E/M/S/X Series device (with one or two I/O connectors)
2
–
100-pin E Series device
Cable(s) for DAQ device(s), as listed in Table 1
The
E Series User Manual
, the
M Series User Manual
, the
S Series User Manual
, or the
X Series User Manual
BNC cables
28–16 AWG wire
Wire strippers
Flathead screwdriver
Installing the BNC-2120
Caution
When this symbol is marked on a product, refer to the
Read Me First:
Safety and Radio-Frequency Interference
document for information about
precautions to take.
Figure 1 shows the front panel of the BNC-2120.
1
You can use two BNC-2120 accessories with both connectors of two connector M/X Series devices.
2
You cannot use the BNC-2120 with Connector 1 of NI 6225/6255 devices.
