©
National Instruments Corporation
7
CB-27 Connector Block Installation Guide
Figure 2.
Connecting Signals to the CB-27
You now can connect the connector block to the PR27-30F or PSH32-30F
cable.
Removing the Cable
To remove the PR27-30F or PSH32-30F I/O cable, complete the following
steps:
1.
Grasp the cable connector near the DAQ device and pull it straight out.
If you pull the cable out using a rocking motion or pull directly on the
cable, you can damage the pins on the cable or on the DAQ device.
Remember to push on the latching ears of the PSH32-30F cable before
disconnecting it from the NI PCMCIA-4350.
2.
Press outward on the ejector ears of the CB-27 connector to pop the
cable connector out.
1
Top Cover
2
Front Panel
3
Tie Wrap
4
Strain-Relief Tabs
5
Signal Wires
6
Cover Screws
7
Screw Terminals
8
Ejector Ears
9
30-Position Connector
1
2
3
4
5
6
6
7
8
9
