Power Requirements
Voltage input range
19 V to 30 V
Maximum power input
20 W
Maximum power consumption
20 W
Physical Characteristics
If you need to clean the module, wipe it with a dry towel.
Tip
For two-dimensional drawings and three-dimensional models of the C Series
module and connectors, visit
and search by module number.
Screw-terminal wiring
Gauge
0.13 mm
2
to 2.1 mm
2
(26 AWG to 14 AWG)
copper conductor wire
Wire strip length
6 mm (0.24 in.) of insulation stripped from the
end
Temperature rating
85 °C
Torque for screw terminals
0.20 N · m to 0.25 N · m (1.8 lb · in. to
2.2 lb · in.)
Wires per screw terminal
One wire per screw terminal
Ferrules
0.25 mm
2
to 1.5 mm
2
Connector securement
Securement type
Screw flanges provided
Torque for screw flanges
0.3 N · m to 0.4 N · m (2.7 lb · in. to
3.5 lb · in.)
Dimensions (unloaded)
286.4 mm × 88.1 mm × 58.9 mm
(11.3 in. × 3.5 in. × 2.3 in.)
Weight
929 g (32.7 oz)
Safety Voltages
Connect only voltages that are within the following limits:
V terminal to C terminal
35 V maximum, Measurement Category I
Measurement Category I is for measurements performed on circuits not directly connected to
the electrical distribution system referred to as
MAINS
voltage. MAINS is a hazardous live
electrical supply system that powers equipment. This category is for measurements of voltages
from specially protected secondary circuits. Such voltage measurements include signal levels,
NI cRIO-9074XT User Manual and Specifications
|
© National Instruments
|
19
