cRIO-FRC Operating Instructions and Specifications
14
ni.com
USER1 Switch
You can define the USER1 switch for your application. Use the FRC
ReadSwitch VI in your LabVIEW RT embedded VI to read the value of the
USER1 switch. For more information about the FRC ReadSwitch VI, refer
to the
LabVIEW Help
.
NO FPGA Switch
Push the NO FPGA switch to the ON position to prevent a LabVIEW
FPGA application from loading at startup. The NO FPGA switch overrides
the CompactRIO reset options described in the
Boot Options
section. After
startup you can download to the FPGA from software regardless of switch
position.
Using the RESET Button
Pressing the RESET button resets the processor in the same manner as
cycling power.
Note
The FPGA continues to run unless you select the
Autoload on Any Device Reset
boot option. Refer to the
Boot Options
section for more information.
Understanding LED Indications
Figure 13.
cRIO-FRC LEDs
POWER LED
The POWER
LED is lit while the cRIO-FRC
is powered on. This LED
indicates that the power supply connected to the chassis
is adequate.
FPGA LED
You can use use the FRC LEDs VI to set the state of the FPGA LED. Refer
to the
LabVIEW Help
for more information.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com