Module Immobilization accessory provides extra system assurance and security when shipping
and installing systems, and prevents accidental removal from a system during operation.
When using the Module Immobilization accessory, NI recommends installing the accessory
prior to mounting the system in any enclosure because the accessory requires tool access to the
top, right, and bottom of the cRIO-9031.
What to Use
•
cRIO-9031
•
C Series modules
•
Module Immobilization accessory kit, 158534-01
–
Module immobilization bracket
–
Installation screws
1
•
M4 x 0.7 button-head screw, 8 mm
•
M3 x 0.5 flat-head screws (x2), 10 mm
•
Torx T10/T10H driver
•
Torx T20/T20H driver
What to Do
Complete the following steps to install the Module Immobilization accessory.
1
The Module Immobilization accessory kit includes two sets of screws. One set is a standard set of
screws that require a standard driver type, Torx T10 and T20. The other set is a tamper-resistant set
of screws that require a security driver type, Torx T10H and T20H. Use the tamper-resistant set to
help prevent unintended modification of the system.
22
|
ni.com
|
NI cRIO-9031 User Manual
