Floppy Drive BBS Priorities Submenu
The Floppy Drive BBS Priorities submenu specifies the boot priority of floppy drive devices.
Boot Option #1, Boot Option #2, Boot Option #3—These settings specify that the main Boot
Option Priorities list displays the highest priority device. Optionally, each device can be
disabled if the device is not used as a boot device.
Network Device BBS Priorities Submenu
The Network Device BBS Priorities submenu specifies the boot priority of network devices.
Boot Option #1, Boot Option #2, Boot Option #3—These settings specify that the main Boot
Option Priorities list displays the highest priority device. Optionally, each device can be
disabled if the device is not used as a boot device.
Security Menu
Use this menu to enable BIOS security options.
•
Setup Administrator Password—This setting specifies a password that must be entered to
access the BIOS Setup Utility. If only the Administrator’s password is set, then this only
limits access to the BIOS setup utility and is only asked for when entering the BIOS setup
utility. By default, no password is specified.
•
User Password—This setting specifies a password that must be entered to access the
BIOS Setup Utility or to boot the system. If only the User’s password is set, then this is a
power on password and must be entered to boot or enter the BIOS setup utility. In the
BIOS setup utility, the User has Administrator rights. By default, no password is
specified.
Save & Exit Menu
The Save & Exit setup menu contains all available options for exiting, saving, and loading the
BIOS default configuration. As an alternative to this menu, press <F9> to load optimal BIOS
default settings and <F10> to save changes and exit setup.
The Save & Exit setup menu includes the following settings:
•
Save Changes and Reset—This setup utility then exits and reboots the cRIO-9081. Any
changes made to BIOS settings are stored in NVRAM. The <F10> key also selects this
option.
•
Discard Changes and Reset—Any changes made to BIOS settings during this session of
the BIOS setup utility are discarded. The setup utility then exits and reboots the
controller. The <Esc> key can also be used to select this option.
•
Save Changes—Changes made to BIOS settings during this session are committed to
NVRAM. The setup utility remains active, allowing further changes.
•
Discard Changes—Any changes made to BIOS settings during this session of the BIOS
setup utility are discarded. The BIOS setup continues to be active.
38
|
ni.com
|
NI cRIO-9081 User Manual