Builder, and configure the application in LabVIEW to launch at startup. If you already have an
application configured to launch at startup and you push the NO APP switch from ON to OFF,
the startup application is automatically enabled. For more information about automatically
launching VIs at startup and disabling VIs from launching at startup, refer to the
Running a
Stand-Alone Real-Time Application (RT Module)
topic of the
LabVIEW Help
.
USER1 Switch (RT Only)
You can define the USER1 switch for your application. To define the purpose of this switch in
your embedded application, use the RT Read Switch VI in your LabVIEW RT embedded VI.
For more information about the RT Read Switch VI, refer to the
LabVIEW Help
.
NO FPGA Switch
Push the NO FPGA switch to the ON position to prevent a LabVIEW FPGA application from
loading at startup. The NO FPGA switch overrides the reset options described in the
System
Reset Options
section. After startup you can download to the FPGA from software regardless
of switch position.
Restoring the Hard Drive to Factory Default Condition
(Windows Only)
You can restore the hard drive of the cRIO-9081 to factory default condition either from a
recovery partition on the hard drive or from the NI Embedded Controller OEM Re-Installation
DVD shipped with thecRIO-9081.
In order to use the hard-drive recovery partition, you must press and hold <F4> during the
POST to launch the recovery utility. In order to use the recovery DVD, you must connect an
external DVD-ROM drive to one of the USB ports of the cRIO-9081. For more information
about restoring the hard drive to factory default condition, go to
and enter the Info
Code
hdrecovery908x
.
Note
Restoring the hard drive to factory default condition erases the contents of
the hard drive. Back up any files you want to keep before restoring the hard drive.
Installing an Operating System
The cRIO-9081 is shipped with an operating system installed. You can use an external CD/
DVD-ROM drive, connected to one of the USB ports, to install a different operating system
such as Windows Embedded Standard 7 Runtime (WES7). For more information about
installing an operating system on the cRIO-9081, go to
and enter the Info Code
hdrecovery908x
.
cRIO-9081 Features
The cRIO-9081 provides the following features.
Ports and Connectors
The cRIO-9081 provides the following ports and connectors.
NI cRIO-9081 User Manual
|
© National Instruments
|
5