cRIO-FRC, Gasket Kit, ESD wristband, compressed air, #1 screwdriver, and clean paintbrush
Preparation:
•
Clean your work area. You should disassemble the cRIO-FRC in a location free of dust and
metallic debris.
•
Properly ground yourself and the cRIO-FRC to prevent any electrostatic discharge (ESD) by using
an ESD wristband and mat.
•
Take off all rings, bracelets, and dangling necklaces to reduce the risk of ESD
Disassembling the cRIO-FRC
CAUTION
When handling the cRIO-FRC circuit board, never hold it by the components or connectors. Make sure to
hold the board only by the edges. Do not touch the integrated circuits. Before starting, make sure you
have read the above sections listing the tools and preparation required.
1.
Remove all external components from the cRIO. This includes any I/O modules, dust covers,
power cable and connector, and any Ethernet or serial cables.
Summary of Contents for cRIO-FRC
Page 10: ......
