Cleaning the cRIO-FRC
CAUTION
Use only compressed air to clean the cRIO-FRC. Do not clean the cRIO-FRC casing or PCB with any
cleaners or solvents.
CAUTION
When using compressed air, do not hold the can upside down or in a manner that causes liquid
propellant to spray onto the cRIO-FRC casing or PCB.
1.
Hold the chassis away from your work surface and use compressed air to dislodge and remove
debris from all sides of the chassis. Note that holding the chassis away from the work surface
removes the risk of blowing debris from the chassis to the PCB.
Removing debris from the chassis with compressed air
2.
Check to see if there are any foreign objects on or in the chassis that were not dislodged by the
compressed air. If so, use a small, soft, clean, dry paintbrush to remove the debris.
Summary of Contents for cRIO-FRC
Page 10: ......
