Index
©
National Instruments Corporation
I-21
DAQ-STC Technical Reference Manual
DIV_LOAD signal
description (table), 2-114
DIV counter operation, 2-129
DIV_TC signal
counter outputs (figure), 2-106
description (table), 2-114
pin interface description (table), 2-20
documentation
about this manual, xxiii
conventions used in manual, xxv
National Instruments documentation, xxvi
organization of manual, xxiii-xxiv
related documentation, xxvi-xxvii
E
edge detection, trigger selection and
conditioning
analog input timing/control
module, 2-122
analog output timing/control
module, 3-116
electronic support services, E-1 to E-2
e-mail support, E-2
Enable_Gi_Out function, 4-35
end of scan, analog input programming,
2-37 to 2-38
EOC signal
ADC control, 2-7
basic analog input timing, 2-86
description (table), 2-21
simplified analog input model, 2-5
error detection
analog input timing/control module
overflow error, 2-132
overrun error, 2-132
ST_TC error, 2-132
analog output timing/control module,
3-122 to 3-123
BC_TC error, 3-123
BC_TC trigger error, 3-123
overrun error, 3-122
UI2_TC error, 3-123
ETS, pulse generation for
description, 4-15
programming, 4-33 to 4-34
event counting, 4-3 to 4-6
buffered cumulative event counting, 4-5
buffered noncumulative event counting,
4-4 to 4-5
programming
buffered event counting, 4-20 to 4-22
relative position sensing, 4-23 to 4-24
simple event counting, 4-19 to 4-20
relative position sensing, 4-6
simple event counting, 4-4
simple gated-event counting, 4-4
Event_Counting_ISR function, 4-22
EXT_DIVTC signal (table), 2-114
EXT_GATE signal
analog input timing/control
description (table), 2-114
trigger routing logic (figure), 2-121
analog output timing/control
description (table), 3-111
routing logic (figure), 3-115
EXT_GATE2 signal
description (table), 3-111
routing logic (figure), 3-115
external CONVERT mode
CONVERT timing, 2-10 to 2-11
free-run gating mode timing, external
CONVERT (figure), 2-110
START and SCAN_IN_PROG trigger
output, 2-102
START trigger output, 2-102
START1 and START2 triggers in
synchronous mode, 2-97 to 2-99
external CONVERT source, 2-92 to 2-93
external gating. See gating.
external multiplexer control, 2-7 to 2-9
