© National Instruments
|
1-7
Mounting NI USB X Series Devices
(NI USB-63
xx
Screw Terminal/Mass Termination Devices)
You can use your NI USB
X Series device on a desktop, mount it to a wall or panel as described in the
section, or mount it to a standard DIN rail as described in the
section.
Panel/Wall Mounting
Complete the following steps to mount your NI USB X Series device to a wall or panel using the
USB X Series mounting kit (part number 781514-01 not included in your USB X Series device
kit). Refer to Figure 1-3.
1.
Use three #8-32 flathead screws to attach the backpanel wall mount to the panel/wall.
Tighten the screws with a #2 Phillips screwdriver to a torque of 1.1 N · m (10 lb · in.).
Figure 1-3.
Using the USB X Series Mounting Kit on a Wall or Panel
2.
Place the USB X Series device on the backpanel wall mount with the signal wires facing
down and the device bottom sitting on the backpanel wall mount lip.
3.
While holding the USB X Series device in place, attach the front bracket to the backpanel
wall mount by tightening the two thumbscrews.
Summary of Contents for DAQ X NI 634 Series
Page 1: ...PXIe 6349...
