©
National Instruments Corp.
3
FP-RTD-122 and cFP-RTD-122
To install the cFP-RTD-122, refer to Figure 2 and complete the
following steps:
1. Align the captive screws on the cFP-RTD-122 with the holes
on the backplane. The alignment keys on the cFP-RTD-122
prevent backward insertion.
2. Press firmly to seat the cFP-RTD-122 on the backplane.
3. Using a number 2 Phillips screwdriver with a shank of at least
64 mm (2.5 in.) length, tighten the captive screws to 1.1 N
⋅
m
(10 lb
⋅
in.) of torque. The nylon coating on the screws prevents
them from loosening.
Figure 2.
Installing the cFP-RTD-122
1
cFP-RTD-122
2
Captive Screws
3
cFP Controller Module
4
Screw Holes
5
cFP Backplane
2
2
1
3
5
4
4
