Installing Your GPIB-SCSI-A and NI-488.2 for Solaris
10
ni.com
Step 3. Switch On Your GPIB-SCSI-A
Switch on your GPIB-SCSI-A by using the rocker switch on the rear panel. The
POWER
LED should come on immediately and the
READY
indicator on the
front panel should come on after the GPIB-SCSI-A has passed its power-on
self-test, indicating that the unit is ready for operation.
If the
READY
indicator does not come on within 10 seconds after the unit is
powered on, recheck all connections and switch settings and retry the power-on
sequence. If the
READY
light still fails to come on, contact National Instruments.
Step 4. Power On Your System
Complete the following steps to power on your system:
1. Plug the power cords of the Sun SPARC system and any other SCSI
equipment into a power outlet.
2. Power on all devices.
3. Power on your system.
Installing NI-488.2
Complete the following steps to install NI-488.2 for Solaris:
1. Insert the NI-488.2 for Solaris installation CD.
2. You must have superuser privilege before you can install NI-488.2 for Solaris.
If you are not already a superuser, type
su root
and enter the root password.
