Chapter 1
User Interface
©
National Instruments Corporation
1-5
Select Toolbar
The
Select
toolbar contains the functions used to control selection filters,
and appears by default when you run Ultiboard. Please note that all filters
are not available in all versions of Ultiboard. The
Select
toolbar buttons are
explained in the table below.
Place Via
button. Places a via on the design. Refer to the
, for more information.
Place Copper Area
button. Places a copper area on the
design.
Create Power Plane
button. Places a powerplane on the
design. Refer to the
section of
Chapter 5,
Working with Traces and Copper
, for more
information.
Design Rule Check
button. Runs the
Design Rule
Check
and places results in the
Results
tab.
Place Text
button. Places text on the design. Refer to the
section of Chapter 8,
, for more information.
Show 3D
button. Displays the current design in three
dimensions. Refer to the section of Chapter 9,
, for more information.
Help
button. Displays the helpfile contents page.
Button
Description
Enable Selecting Parts
button. Use to allow or prevent
selection of parts.
Enable Selecting Traces
button. Use to allow or prevent
selection of traces.
Button
Description
